Figuring Out the Samsung Washer SE Error Code

Having an error code display on any washer can be an alarming sight. It can cause unnecessary worry and stress when we’re unable to identify the issue. This article will discuss what an SE error code is typically associated with when it appears on a Samsung washer and how to fix it.

When you see an SE code appear on the LCD display of a Samsung washer, it typically indicates that either the water level is too high or the pressure sensor is not working correctly. There are several troubleshooting steps that should be taken when this code appears.

First, you must unplug the washer from the power source. After this is done, the pressure sensor should be first checked for any problems. This part can often be located near the bottom of the washer tub. If the pressure sensor is found to be working properly, the water levels should next be checked. If the water levels are too high, the drain hose must be disconnected, and the excessive water must be pumped out.

Finally, after completing all the steps above, plug the washer back in and turn it back on. After a few minutes on the start cycle, the washer should begin running again. If the SE code is still displaying after going through the suggested solutions, then it might be time to call a technician and have them inspect the washer.

An SE code on a Samsung washer can be quite alarming, but thankfully it can usually be resolved fairly quickly. It’s always helpful to have a Comprehensive Appliance Error Codes Glossary handy that you can reference in these types of cases. Don’t forget to check out our Comprehensive Appliance Error Codes Glossary for more information on the SE code and any other potential codes you may encounter.

Dealing with SE Error Code on Samsung Washer

Q: What does the SE error code mean on my Samsung washer? A: The SE error code on Samsung washers indicates a problem related to the washer’s motor.

Q: How can I check for potential causes of the SE error code? A: To check for potential causes of the SE error code on your Samsung washer, you should first check to make sure the washer is level. Check to make sure the washer is firmly plugged into its power source. Check inside the washer for any large items that may be stuck, blocking the motor.

Q: How do I reset the Samsung washer when the SE error code is displayed? A: To reset the Samsung washer when the SE error code is displayed, disconnect the power cord from the wall outlet or turn the circuit breaker off. Wait for at least 10 seconds and then reconnect the power cord or adjust the circuit breaker.

Q: What should I do if the SE error code continues to be displayed after resetting the washer? A: If the SE error code continues to be displayed after resetting the washer, it is recommended that you contact an authorized service technician for further assistance.

Q: Are there any potential safety risks associated with the SE error code on Samsung washers? A: Yes, in some circumstances, the SE error code can indicate a potential safety hazard. If the SE error code persists after following the reset procedure and you are unable to determine the cause of the code, it is recommended you contact an authorized service technician to have it looked at before continuing use of the washer.

Solved! What to Do About SE Error Code on Samsung Washer

  1. When you see an SE code appear on the LCD display of a Samsung washer, it typically indicates that either the water level is too high or the pressure sensor is not working correctly.
  2. First, unplug the washer from the power source. Check the pressure sensor, and if it is found to be working properly, check the water levels.
  3. If the water levels are too high, disconnect the drain hose and pump out the excessive water.
  4. Plug the washer back in, turn it back on and after a few minutes the washer should begin running again.
  5. If the SE code is still displaying after going through the suggested solutions, call a technician for inspection.